Zipped Cot Bumper Wabi-Sabi: Fitting and Washing Guide
By Timeless design furniture, home decor and textiles | Nobodinoz | Published: 2026-11-04
Category: How-to Guides
Learn how to fit and wash the zipped cot bumper in washed cotton Wabi-Sabi. Step-by-step guidance and safety checks for a cosy, secure cot.
Quick answer
Fit the zipped cot bumper by securing it to the outside of the cot rails, covering only the lower half so your baby keeps a clear view. Unzip the cover and machine wash it on a gentle cycle when needed, then air-dry fully before refitting.
Why the half-height design matters for fitting
The Wabi-Sabi cot bumper is intentionally designed to cover only half the cot. This keeps the upper portion open, allowing airflow and giving your baby a clear view. When fitting, resist the urge to raise it higher or tuck it behind the mattress; the bumper should sit below the top rail and never interfere with your baby's breathing space.
When to use a cot bumper (and when to skip it)
Cot bumpers are not recommended for newborns or babies who cannot yet roll away from them. If your baby is under 12 months or has limited mobility, skip the bumper entirely. Use it only when your baby is active and can move freely, and always follow safe sleep guidelines. The zipped design makes it easy to remove for cleaning, but never leave it in the cot if it becomes loose or damaged.
Step-by-step fitting and washing instructions
- Prepare the cot and bumper: Remove all bedding and ensure the cot rails are clean and dry. Unzip the bumper cover and check that the inner padding is intact and free from tears. Lay the bumper flat to identify the top and bottom edges. A quick inspection now prevents surprises later.
- Position the bumper on the outside: Wrap the bumper around the outside of the cot rails, aligning the bottom edge with the mattress base. The bumper should cover only the lower half of the cot side, leaving the top half open. Do not place it inside the cot or over the mattress. Check that the bumper does not rise above the halfway point of the cot side.
- Secure the ties or fastenings: Tie the bumper securely to the cot rails using the provided ties or fastenings. Double-knot each tie and tuck away any loose ends. Ensure the bumper is snug and cannot be pulled into the cot by your baby. Give the bumper a gentle tug to confirm it is firmly attached.
- Perform a safety check: With the bumper in place, check that there are no gaps between the bumper and the mattress, and that the bumper does not interfere with the mattress fit. Ensure your baby cannot reach the ties or pull the bumper down. The bumper should not obstruct your view of your baby from outside the cot. If you can easily slip a finger between the bumper and the cot rail, it is too loose.
- Remove the cover for washing: Unzip the cover and slide it off the padding. Machine wash the cover on a gentle cycle with mild detergent, following the care label. Do not bleach or tumble dry on high heat. Zip the cover closed before washing to prevent it snagging on other items.
- Dry and refit: Air-dry the cover completely before refitting. Once dry, slip the cover back over the padding and zip it closed. Refit the bumper to the cot following the positioning and securing steps above. Never refit a damp cover; moisture can encourage mildew.
Product facts
- Zipped cot bumper in washed cotton Wabi-Sabi: The ultra-soft Wabi-Sabi cot bumper covers half the cot and adds a cosy touch. The half-height coverage keeps the upper cot open for airflow and visibility, which is important for safe sleep.
Zipped cot bumper in washed cotton Wabi-Sabi - Zipped cot bumper in washed cotton Wabi-Sabi: Its cover has a practical zip for washing. You can remove the cover quickly for regular cleaning without removing the entire bumper structure.
